Adjustable Temporary Shoring Support
The Shore Jack™ is a convenient and durable way to make structural repairs and to function as temporary support for various construction and remodeling projects.
TheShore Jack™ along with a 4″ x 4″ wood post cut to a custom length becomes a versatile adjustable column.
Use a 4″ x 4″ wood post and cut to desired length.
Transforms a nominal 4″ x 4″ lumber into an adjustable building product.
- Recommended as a temporary or non-primary support.
- Load capacity dependent on a 4 x 4 used up to 24,700 lbs.
- Consult with your wood supplier for allowable load.
TEMPORARY SHORING JACK SPECIFICATIONS
MODEL# | ADJUSTMENT RANGE | UPC |
---|---|---|
S301944PC | 4" | 890475001301 |
Fits a 4″x 4″ timber post (3.75″x 3.75″ ID), height fully retracted: 14 5/16″, 4″ screw adjustment fully extended equals overall height at 18 5/16″
Shore Jack Installation Instructions
➊ Select the appropriate 4 inch by 4 inch (4x4 nominal) lumber based on construction documents.
➋ Measure the vertical height required for the Shore Jack™ Assembly.
➌ Subtract ten inches from measured height and use this new measurement for the length of the 4x4.
a. Note: Shorter length 4x4s can be used; however, this will require more adjustment of the adjusting screw. The adjustment range of the shore jack™ is recommended a maximum of 4 inches.
➍ Insert the 4x4 into the square tube of the jack and install four 2-1/4″ inch 8d nails in the holes provided in the square tube walls. The nails will fit through the holes and shall partially penetrate the 4x4 holding the 4x4 to the square tubing.
a. Note: If intending to reuse the jack, do not drive the nail head flush with square tube, but leave the nail head partially out to allow for easier removal. This is not required if using wood screws.
➎ Make sure the it is centered under the horizontal member (beam, joists, etc.) that is required to support.
➎ Turn the adjusting screw until the 4x4 is firmly supporting the horizontal member
7 Use a level to vertically plumb 4x4 and verify the 4x4 is centered under horizontal member.
For more information on how to install the Shore Jack click here.
Use for:
- Construction projects
- Repairs or installations
- Renovations
- Sagging floors
- Crawl spaces